[support] Re: crude/rude ipv6 problem

[Romain KUNTZ]

Hi Markus,

I've tested your configuration file with rude on my computer, it works  
fine and I could see with tcpdump the udp packets sent over my network  
interface. The output I had on the terminal was:

$ ./rude -s rude.conf
rude version 0.62, Copyright (C) 1999 Juha Laine and Sampo Saaristo
rude comes with ABSOLUTELY NO WARRANTY!
This is free software, and you are welcome to redistribute it
under GNU GENERAL PUBLIC LICENSE Version 2.
read_cfg() - read comment (line #=1)
[snip]
read_cfg() - read START NOW (line #=11)
read_cfg() - read comment (line #=12)
[snip]
read_cfg() - read CMD ON (line #=26)
find_flow_id() - flow not found (id=30)
check_type() - EXIT(1)
check_dst() - address=2001:1:1::1000 port=5001
flow_on() - CBR flow id=30 created
read_cfg() - read CMD OFF (line #=27)
find_flow_id() - flow found (id=30)
flow_off() - flow (id=30) turned off
read_cfg() - read comment (line #=28)
read_cfg() - read comment (line #=29)
read_cfg() - read comment (line #=30)
read_cfg() - read comment (line #=31)
read_cfg() - read comment (line #=32)
read_cfg() - max_packet_size set to 250
read_cfg() - EXIT (cmd/err=32/0, lines read=32)
open_sockets() - EXIT(0)
init_rude() - EXIT(0)
rude: start LOOPING

rude_handler(): receiver SIGNAL 2 - clean-up & exit
clean_up(): DONE



Did you get any error at configure or compilation time? Is your  
interface able to send packets using IPv6 when you execute rude ?

Cheers,
romain

On 2008/09/22, at 11:33, marcus wrote:

> Hi Romain,
> yes I did checked it with strace. But I couldn figure out a problem.
> Sorry I forgot about to add the strace log file. Here it is, you can
> find it attached to my mail.
> I use the command: "rude -s /etc/rude.conf" to start rude.
>
> Thanks in advance.
>
> cheers, Marcus
>
> Am Sonntag, den 21.09.2008, 20:44 +0200 schrieb Romain KUNTZ:
>> Hi Marcus,
>>
>> On 2008/09/20, at 11:22, marcus wrote:
>>> But it still does not work. Now rude still stops immediately after I
>>> started it. Does anybody have any idea why that happens.
>>
>>
>> Have you tried to execute rude through strace for example? This might
>> give further information.
>>
>> Regards,
> -- 
> Mit Freundlichen Grüßen
>
> Marcus Trinks
> ---------------------------
> Ginsterweg 41
> 38820 Halberstadt
> Mobil: 01577 5746169
> Email: Marcus.Trinks at gmx.de
>
> <rude_strace.log><rude.conf>